Welcome to DIY lesson of April, this is the new edition of this wonderful and lehhreichen show with our star presenter Aidan. The April issue is, how do I replace my bathroom roof?
Well, quite simple. First, of course, the wood slats are torn down. Since there is no crowbar, you take your old one spade, it works. First, the tar residues are carved on the roof, so that the spade can be inserted between the boards. Then you use the spade as a lever to the boards to tear off its hinges. Can be a problem if the nails are rusted. Aidan DIY Tip: Keep trying. If all boards must
off the new metal roof panels are prepared: First wash, then paint (on the bottom), then cut to the ... ööööh ... jesses ... how do you say to that in German? Angle Grinder. Aidan says: cut the sheet itself, but let the henchman on the roof measure the length and curve. Sun will then lifted the sheets on the roof (note: please do not perform construction work in cases of heavy wind, it's dangerous.) And placed in the correct position. Huge hammer and nails' income. (And do not banging Rachel let that get no nails are longer than 2cm in a board in) Then the next panel -. it must be the first by about 10 cm overlap. All sheets nailed. Then the end they must be cut straight, and go! (Plaster work inside the house the women left.) :-)
0 comments:
Post a Comment